Will support you for ever, check Support method from: HERE
This sensor work as NO Mode, Normally connect to another master device, detect and trigger door open, it's like a button/switch.
If you want it work as Normal close mode, we have solution, just add one small module, please contact us.
2. The connection idea is:
- Quick Test: Sensor's Brown wire to Power unit's 12V; Sensor's Yellow wire to Power unit's GND; this is to power on the motion sensor. then put hand in front of the sensor, it will have click and the LED lights up.
- If you use it with your own access control system, Sensor's Green wire and White wire are used as contact signal to trigger open(Like a push button) ,you can also send me email for how to wire.
- If you use it with our small power unit(Below Picture), the wire Video guide:
https://vimeo.com/712812114/45cf6d9179
- If use it connect with our control panel(Below Picture), check the connection video from:
https://vimeo.com/712812114/45cf6d9179
3. TIPS:
can adjust sensitivity and angle/detection area. if too sensitive, can also use electric tage, put inside the cover, so that it has some certain block for the detection. check the video from below link:
https://vimeo.com/1026818687/1add751f87
I will support you for ever with my nearly 20 years experience.
1. If you prefer email, I will do email support.
2. If you want phone support, I can call you( Please tell me your phone number)
3. Also can do teamviewer support to remotely connect to your computer to guide you, to provide live training and support for you.